How to Fix A Noisy Electric Fire?

Electric fireplaces come in handy during the cold seasons like the winter. They heat rooms faster than burning wood fireplaces. This results to a reduction in energy cost. In addition, the modern electric fire is much safer than gas or firewood. This is because of the lack of open fire and also the reduced need for chimneys and venting. They don’t produce carbon monoxide fumes and you can leave the fire on for some time without any fear. Electric fireplaces are way better than their counterparts because they eliminate the huge task by a simple click on a switch. You can find the best electric fires here.

 Electric fires usually operate silently, but after some time, perhaps due to the long duration of usage, you may start hearing some noises from the place. No need to panic, try applying the following steps to eliminate the noise.

First step: Tighten the hardware connections

As mentioned earlier, the electric fireplace is usually very silent in operation, any noise can be triggered by the loose hardware connections. The first thing to do when you notice any kind of noise is to check whether the screws of the fireplace are held tightly in place. If that is not the case then you have to find a wrench and a screwdriver to tighten them up. This should stop the noise if at all that was the cause of it. When you turn the fireplace on and still experience the noise, try the second step.

Second step: The tubes

The tubes connecting the whole equipment are other possible noise producers when they bend a little. Check and find out if that is what causes the noise to be produced. If the tubes are bent even slightly, use a hammer to straighten them back in place. Do this gently so as not to damage them.

Third step: The blower

For some time, the fan or blower of the fireplace tend to accumulate a lot of dust and lint. If the first two steps haven’t solved the noise problem, try cleaning out the blower to get different results. You can do this using dusting cloths. The air will blow out clean and quiet.

Fourth step: The fan belt

When in use for some time, the rod tends to wear out and stick. This is one possible way that the fireplace will produce a squeaking noise. The best thing to do here is to lubricate the belt using industrial oil. Open the back of the fireplace panel and oil the rod to fix the squeaking issue. Alternatively, you can just replace the rod if possible.

Fifth step: The motor

With time, the motor gets old and begin to produce a grinding sound. The best thing to do here is to replace the motor or the speed control. Check with the manufacturer’s guide to replace the motor.

Sixth step: The limit switch

After turning on, overloading and shutting down, the limit switch may break out with time. This will in turn, cause the fireplace to produce a noise which can be pretty annoying. To fix this issue, open the whole unit and find round discs with two wires. Replace them and see if the problem is fixed.

Electric fires producing noise is probably due to the things outlined above. Sometimes these steps may fail to work but this only happen in rare cases. If you happen to check all of them and fix where you can and still the problem persists, it is always good to consult your owner’s manual. The problem may be that the whole system needs to be changed.

About the Author Harry Thompson

Gaining a BSc Honours in building/ property maintenance at the University of Portsmouth Harry went into the field of renovating properties. Along the journey, he has developed a wide variety of home & garden DIY skills such as installing new kitchens and landscaping gardens.